Tuesday, September 11, 2012 - Friday, September 14, 2012

IMV Training Course

All Day Event

This course is recommended for individuals with less than two years experience and prepares attendees to perform a range of simple channel machinery vibration condition monitoring and diagnostic activities. It also serves as partial preparation for the Category I Vibration Analyst Certification Examination. All Vibration Institute instructors are Category IV certified and experienced vibration analysts. Course Instructors are subject to change without prior notification.

INTRODUCTION to MACHINERY VIBRATIONS (IMV)

All registered attendees in the Introduction to Machinery Vibrations training course will receive class notes and a workbook containing examples and workshop problems, calculator and a ruler. Workshops are scheduled to illustrate theory and applications. This course provides preparation for plant data collection and limited analysis as well as partial preparation for the certification examination for the Vibration Analyst Category I.

DAY ONE

• Vibration: Sources, Uses, Effects
• Background, definitions, sources, effects, uses, predictive maintenance, measurement concepts, equipment
• Workshop I: Vibration Demonstration and Workshop Questions
• Basic Machinery Vibrations I
• Physics; units; properties; measurement conventions; motions; amplitude; frequencies; time, frequency, and orbital domains
• Workshop II: Definitions, Terminology, Measurements, Demonstrations

DAY TWO

• Basic Machinery Vibrations II
• Measures, conversions, analysis, excitation, natural frequencies, resonance, and critical speeds
• Workshop III: Measure Analysis, Natural Frequencies, and Demonstrations
• Data Collection
• Physical observations, sensors, frequency spans, measures, triggering, sensor mounting and location, instruments
• Workshop IV: Data Collection Demonstration and Workbook Questions

DAY THREE

• Machine Knowledge
• Fault sources, frequencies, design and function of machines
• Vibration Testing
• Periodic and permanent monitoring, machine analysis (fault and condition), acceptance testing
• Workshop V: Vibration Testing
• Basic Spectrum Analysis
• Frequency identification and matching and procedures
• Workshop VI: Spectrum Analysis and Demonstrations

DAY FOUR

• Common Machine Faults
• Mass unbalance, misalignment, looseness, bearing defects, and electrical defects
• Workshop VII: Fault Analysis
• Vibration Severity
• Criteria, procedures, charts on housings, shafts, and bearings
• Workshop VIII: Vibration Severity
• Course Review
• Training Examination on Course Content (One hour)

Upon receipt of your registration you will receive a confirmation letter with additional information regarding your specific training course. 

All Vibration Institute instructors are Category IV certified and experienced vibration analysts.  Course Instructors are subject to change without prior notification.
 

Export to Outlook